User`s manual

centre, mount the revolving bracket as in 7c or with the chain

fixture. Use the extension fixture and the rods.

If the movable machine does not have a tapped hole and cannot be

rotated, mount the lapped steel bar with the revolving bracket in its

centre.

Mount a target and an extension bracket on each revolving bracket and then

mount the rods. Use the long rods in order to slide the TD-units above the

targets.

PRE-ALIGNMENT FUNCTIONS

In the efforts to obtain the best possible conditions for a shaft alignment it is

necessary to check whether the shafts are bent, the machine base is warped

or if there is a soft foot condition.

The Basic Straightness program is primarily designed for

measurement of shaft and base straightness. See the chapter

Basic Straightness measurement.

The Softcheck function makes it possible to check softfoot

condition. See the chapter Softcheck.

START THE PROGRAM

Start the program by touching the Cardan Shaft Alignment

icon in the Main Menu.

Go to the Application Set-up for settings.