User`s manual

SHAFT ALIGNMENT WITH OL2R

When both Hot Condition and Cold Condition are measured and the OL2R-

measurement is confirmed the difference between Hot and Cold Condition is

shown. This is the Thermal Offset values (as target values).

It is now possible to do a Shaft Alignment with these Thermal Offset values or

save the Thermal Offset values for later use. The Shaft Alignment is done

according to the chapter Shaft Alignment Horizontal machines.

Go to Shaft Alignment using the Thermal Offset values. See

the chapter Shaft Alignment Horizontal machines.

Save Thermal Offset values for later use. See Memory

Manager.