User`s manual

the fixture. Adjust the fixture so that the laser is shining on the

centre of the target on the other OL2R bracket (the TD-M

should not be in place).

Rotate the TD-S to 3 o’clock and find the new location of the

beam. Using a wide ruler or a piece of paper determine the

half-way position between the centre of the target and where

the beam is now located and adjust the beam to that point

using the blue thumbwheels on the TD-units.

Move the Stationary end fixture to bring the beam to the centre

of the target.

Repeat the procedure until the beam stays precisely in the

centre of the target when the TD-S is rotated from 9 o’clock to

3 o’clock.

Remove the TD-S and install the TD-M. Repeat the same coning

procedure for the TD-M so that when it is rotated the beam

stays precisely on the target at the TD-S end.

Install the TD-S and set both TD-units to 12 o’clock. The laser beams

should now be located directly under and over the crossline targets on

the respective TD-units.

Adjust the top thumbwheel on the TD-M until the beam is precisely in