User`s manual

TRIPOINT METHOD

When shafts have a limited rotation or can only be rotated in one direction.

Select the Tripoint™ method in the Application Set-up.

NOTE: The shafts should be coupled during the measurement using the

Tripoint TM method in order to achieve as reliable and accurate results as

possible.

TIP: The larger angle over which the three points are measured, the fewer

moves and repeat measurements will have to be made. Minimum angle

between readings is 30°.

The screen displays the movable machine. Enter dimensions as for the Clock

method. Set the TD units so that they are approximately parallel.

Measurement Procedure