User`s manual

MOUNTING

Attach the V-block fixtures on the shafts of the measurement object, one on

each side of the coupling. Tighten the tension screws firmly, always using the

supplied tool. Do not over-tighten. Mount the rods to the fixture and tighten

firmly. Attach the TD-units on the fixtures. The TD-M should be mounted on

the moveable machine and the TD-S on the stationary machine. If the shaft

diameter is too large the chains can be extended with the optional extension

chains.

Connect the cables between the display unit and the TD-units. There are two

ways you can do this:

1. Connect one cable between the display unit and one of the TD units.

Then connect the second cable between the TD-units.

2. Connect one cable from one of the terminals on the display unit to

one of the terminals on TD-M. Then connect the second cable from

the other terminal on the display unit to one of the terminals on TD-

You can use any of two terminals on each unit. If, for any reason, you detach

a cable during measurement you will need to return to the main menu and

then restart the measurement program.