User`s manual

TOLERANCE TABLE
Alignment tolerances depend to a large extent on the speed of rotation of the
shafts. Machine alignment should be carried out to within the manufacturer’s
tolerances. The table below can be helpful if no limits are specified. The
suggested tolerances can be used as a starting point for developing in-house
tolerances when the machinery manufacturer’s recommended tolerances are
not available. The tolerances are the maximum allowable deviation from
desired values, whether zero or targeted offset for thermal growth.
Open the Tolerance Table by touching its icon in the Application Set-
up.
Tolerance table - metric Tolerance table - imperial
A screen dump can be printed by touching the print icon.
Exit by touching the exit icon.
213