User`s manual

CALIBRATING THE TOUCH SCREEN

To get the touch screen to respond correctly to the icons on the display it

might be necessary to recalibrate it from time to time.

Screen calibrating procedure:

1. Stand in the Main Menu and look at the screen from your normal viewing

angle.

2. Press the start button while pressing somewhere on the screen where there

are no icons (for example in the upper right corner) and hold down for about

15 seconds, until the message “Release start button and keyboard to start”

appears on the screen.

When you release the start button and the touch screen you will see a mark

in the upper left corner of the screen and the following message on the

screen: “Touch keyboard panel at mark”.

3. Touch the mark (+). Use a pointed (but not sharp) object to touch at the

center of this mark.

4. Press the start button to continue.

5. Repeat the procedure, step 3 and 4, for the mark in upper right corner, the

mark in the center of the screen, the mark in the lower left corner and finally

the mark in the lower right corner.

The message: “Calibration ready. Push start button” will now be displayed.

6. Press the start button to complete the procedure.

7. Note: Do not use any sharp objects when pressing on the screen.