User`s manual

Mount the Detector unit on one of the floor fixtures. Note that the cable
connection must be pointing upwards. Turn the T220 turret until the
laser beam hits the Detector surface. Use the cross hair on the Detector
if necessary.
Touch the Datum Mark icon on the Display unit corresponding to the
actual position of the Detector. Wait until measurement values
appear on the screen before you remove the Detector. This may
take a few seconds depending on the selected Sampling Time in the
Application setup.
Move the Detector to the second Datum Mark Pick-Up Fixture and
repeat the procedure.
Touch the OK icon.
Touch the re-measure icon if you need to re-measure.
164