User`s manual

Coarse adjustment
Fine adjustment
Z axis
Y axis
X axis
Aim the laser beam to the center of reflecting tape on the closest Datum
Mark Pick-Up Fixture. Turn the turret on the T220 until the beam hits the
reflecting tape on the furthest Datum Mark Pick-Up Fixture.
Center the beam on the furthest reflecting tape. If the distance is large
you may need to rotate the tripod head, if not you can use the lower
micrometer screw on the T220.
Turn the turret until the laser beam hits the reflecting tape on the
closest Datum Mark Pick-Up Fixture. Centre the beam by adjusting the
T220 sideways with the Slide Table.
Repeat step 4 and 5 until the laser beam hits both reflecting tapes by
just turning the turret.
159