User`s manual

EVALUATION OF MEASUREMENT RESULT
The result is presented in relation to selected references. The direction is
depending on how the receiver is placed. If the receiver is placed according
to the mounting instructions Y-values are showing the vertical direction.
In the vertical direction (Y) positive values mean that the measurement
object at this point is high and negative values that the measurement object
is low (if this is not changed in the application set-up.)
A result box with a filled triangle in the upper right corner shows
that the value is fixed (not live)
ALIGNMENT OF MEASUREMENT POINT
When alignment of measurement point is selected, the sub-screen for
measurement point alignment is shown.
Note: It is recommended to set the screen filter to 0 when aligning.
Position the receiver at the measurement point that should be aligned.
Touch the alignment icon. Make sure that the laser beam hits
the target. The actual values for the selected point go live and
alignment can be made against zero. Zero will be in accordance
to selected references.
Align the selected measurement point to zero.
149