User`s manual

Sampling time
Sets the time (in seconds) used to collect
calculation base for measurement values.
Select between 1 and 99 seconds.
Screen filter
Sets the screen filter on a scale from 0 to
10 where 0 is disabled and 10 is maximum
filtration. This slows down the update
frequency of the screen values without
reducing the accuracy of the registered
values.
Tolerance
Sets the tolerance. When the tolerance is
set symbols are showing if a measurement
point is inside or out of tolerance.
Configuration
Rectangular or circular configuration can
be selected.
+ or - values only
When selecting positive or negative values
only suitable references are automatically
selected. Use only after points are
measured.
Repeatability Test
Starts the sub-function for repeatability
test.
137