User`s manual

Open Application Set-up.

Confirm the measurement when all measurement points are

registered. (After this no more measurement points can be

registered.)

Print a screen dump.

Go to the summary screen.

The measurement screen shows a curve over measured points. The

measurement point number is shown. The Y-and X-values and angle are shown

as live values from the receiver. The diagram scale is also shown below the

diagram.

Y- and X-values at measured points can be looked at by scrolling. (These

values are shown in relation to selected references.)

When the measurement is confirmed the measurement screen is replaced by

the detailed diagram screen.

Selecting reference points

Reference points can be selected in the measurement screen and in the

detailed diagram by touching the points.

To select one reference point, touch the point that you want

to select as reference. If a new reference point is selected

when there are already one or two reference points, touch

the same point twice to get it to be the only reference.

To select a second reference point, touch it and it will be

reference together with the first one. If a new reference

point is selected when there are already two reference points

the first selected will be replaced.