Operator`s manual

15
-
197
[DIMMER] [3] [.] [4] [6] [+] [3] [.] [5] [6]
Puts outputs 1070 and 1080 on the output list.
# THRU # puts a range of outputs to the output list.
[DIMMER] [1] [THRU] [3] or [DIMMER] [3] [THRU] [1]
Puts outputs 1, 2, and 3 on the output list.
[DIMMER] [2] [.] [4] [THRU] [5] [1] [8] or
[DIMMER] [5] [1] [6] [THRU] [2] [.] [6]
Puts outputs 516 through 518 on the output list.
# [-] # removes the listed outputs from the output list. It only
removes outputs that are listed before it in the command.
[DIMMER] [1] [THRU] [3] [-] [2]
Puts outputs 1 and 3 on the output list.
[DIMMER] [1] [THRU] [3] [-] [2] [+] [4]
Puts outputs 1, 3, and 4 on the output list.
Setting Levels
Output levels can be set directly from the command line. The level format depends on the Entry
Mode. You cannot enter fractions of 10% (e.g. 5.1) in Direct 1 Digit entry mode. If you are in the
Live or Patch display you can use the Level Wheel to change the selected dimmer levels until a
new command or the[CLR] key deselects them.
[DIMMER] out [*] or out {UNPATCH} selects the outputs. If already unpatched (i.e. set
by the Output Control) they remain at their unpatched level. Otherwise (if patched) they
are unpatched and initially set to the level of the channel they are being unpatched from.
[DIMMER] [1] [+] [2] [*] All Modes
[DIMMER] [1] [THRU] [2] {UNPATCH} All Modes
Outputs 1 and 2 become the current selection and are unpatched.
[DIMMER] out [@] # selects the listed outputs and sets their levels to # .
[DIMMER] [1] [@] [1] ) Direct 1 Digit
[DIMMER] [1] [@] [0] [1] Direct 2 Digit
[DIMMER] [1] [@] [1] [*] Command Line
Makes output 1 the current selection and sets its level to 1%. This cannot be done in
Direct 1 Digit entry mode.
[DIMMER] [1] [+] [3] [@] [1] Direct 1 Digit
[DIMMER] [1] [+] [3] [@] [1] [0] Direct 2 Digit
[DIMMER] [1] [+] [3] [@] [1] [*] Command Line
Makes outputs 1 and 3 the current selection and sets their levels to 10%.
[DIMMER] out [@] {FULL} [*] selects the listed outputs and sets their levels to Full
(100%). {FULL} is a soft key on the LCD Patch menu. It appears after you press [@].
[DIMMER] [1] [@] {FULL} [*] All Modes
Makes channel 1 the current selection and sets its level to Full.