Operator`s manual

8
-
98
[RECORD] [CUE] [1] [WAIT] [4] [*] Command Line
Records cue 1 with levels and a wait time of 4 seconds. cue [WAIT] # [*]
changes the wait time of the specified cue without changing recorded levels. If
the cue doesn’t exist, creates a new cue with no levels but with the specified wait
time. You do not get an overrecord warning with this command if the cue exists.
[CUE] [1] [WAIT] [*] All Modes
Resets cue 1 wait time to the setting of the Cue Wait field in the User Setup
Screen (Default = OFF)
[CUE] [1] [WAIT] [4] [*] All Modes
Changes the cue 1 wait time to 4 seconds without changing any levels.
Assigning Fade Profiles
Profiles let you change the fade characteristics of cues.
You can assign a profile to the cue, or assign separate profiles to the up fade and down fade.
cue [PROFILE] # [RECORD] Direct 1 and 2 Digit
[RECORD] cue [PROFILE] # [*] Command Line
Records the levels on the current display into the specified cue and assigns a
fade profile to it. If the cue already exists, an overrecord message gives you the
chance to cancel the recording. Press [RECORD] [*] again to record over the
cue or [CLR] or [UNDO] to cancel theoperation. For information on how to create
and edit profiles, refer to Profiles.
If you only enter one fade profile number, it is used for both the up and down fades. To enter
separate up and down fade profiles, use [/] to separate the two numbers. The first number
becomes the up fade profile and the second number becomes the down fade profile.
Separate fade profiles can be assigned to each cue part. To delete an assigned fade profile, omit
the fade profile number. Separate fade profiles can be assigned to each cue part. To delete an
assigned fade profile, omit the fade profile number.
[CUE] [1] [PROFILE] [3] [RECORD] Direct 1 and 2 Digit
[RECORD] [CUE] [1] [PROFILE] [3] [*] Command Line
Records levels into cue 1 and assigns fade profile 3 to both the up and down fades.
[CUE] [1] [PROFILE] [3] [/] [1] [RECORD] Direct 1 and 2 Digit
[RECORD] [CUE] [1] [PROFILE] [3] [/] [1] [*] Command Line
Records levels into cue 1 and assigns fade profile 3 to the up fade and fade profile 1 to the down
fade.
[CUE] [1] [PROFILE] [/] [1] [RECORD] Direct 1 and 2 Digit
[RECORD] [CUE] [1] [PROFILE] [/] [1] [*] Command Line
Records levels into cue 1 and assigns fade profile 1 to the down fade. The up fade profile is set to
0 if this is a new cue, or left as it is if over-recording.
[CUE] [1] [PROFILE] [3] [/] [RECORD] Direct 1 and 2 Digit
[RECORD] [CUE] [1] [PROFILE] [3] [/] [*] Command Line