Installation guide

34
c. If you are using the wireless network, please ensure that:
1.The IP camera is connected to the correct wireless access point.
2.You’ve correctly set the encryption type and key for the connection,
where applicable.
3.If your network does not have a router then the default IP address for this
camera is at 192.168.0.128.
Note: You can check the status of the connection by logging into your
router -> maintenance -> log or similar wordings in your router.
4. Camera Reset
After you’ve check through the above steps, you should be able to use the IP
Utility to scan for the camera which you’ve just installed. If none of the above
worked, please reset the camera and follow the above procedures again.
You can reset the camera to the default state where it will
use the onboard LAN connection and get IP from the
available local DHCP server. To reset the camera, please
power on the camera for 2minutes then press and hold
the reset button on the back of the camera for 10
seconds in order to reset setting to factory default.
Once the camera had been reset, please give it 2minutes to reboot and start the
IP Camera Utility to scan for the camera.