Installation guide

33
2. IP Utility
The scanning of the cameras generally takes around 1minute to complete and
you will see the available cameras populating the screen, as per the figure
blow.
However, should the scanning returned zero cameras found then we can start
the following troubleshooting procedure.
3. Hardware wiring check
a. Please check that the camera had been connected to either the wired or
wireless network and had been powered on for 2minutes. You can check
the status of the IP camera by checking the front blue LED.
b. Please check that your computer has a successful connection to the
network.
Computer has connection
Computer has no connection
Steady
Blinking
Off
Successful
connection to the
network
The camera is
unable to
connect to the
network
The unit is either
not working or
the LED had
been turned off.