Owner manual
4
Table 1: CSC-650 Component / UXGA HDMI Scaler Front Panel Features
# Feature Function
1 IR Receiver Receives signals from the remote control transmitter
2 Selector Button Press to select the UXGA input, the COMP input, or the HDMI
input
3 UXGA Indicator LED
Lights when the UXGA input is selected
4 COMP
Indicator LED
Lights when the COMP input is selected
5
Input
HDMI Indicator LED
Lights when the HDMI input is selected
6 Selector Button Press to select the resolution: 480p, 576p, 720p, 1080i or 1080p
7 480p Indicator LED Lights when the 480p resolution is selected
8 576p Indicator LED Lights when the 576p resolution is selected
9 720p Indicator LED Lights when the 720p resolution is selected
10 1080i Indicator LED
Lights when the 1080i resolution is selected
11
Res.
1080p Indicator LED
Lights when the 1080p resolution is selected
12 MENU Button Displays the OSD menu (see section 6.2)
13 ENTER Button Press to accept changes and change the SETUP parameters
1
14 - Button Press to move down the menu list
1
15
Control
+ Button Press to move up the menu list values
1
Table 2: CSC-650 Component / UXGA HDMI Scaler Rear Panel Features
# Feature Function
16 HDMI Out Connector Connects to the HDMI acceptor
17 3.5mm Mini Jack
Connector
Connects to the analog unbalanced stereo audio
signal
2
18
HDMI In
HDMI Connector Connects to the HDMI source
19 3.5mm Mini Jack
Connector
Connects to the analog unbalanced stereo audio
signal source
20
UXGA In
UXGA 15-pin HD
Connector
Connects to the UXGA source
21 L RCA Connector
22 R RCA Connector
Connect to the left and right analog unbalanced stereo
audio source (of the COMP source)
23 P
R
RCA Connector
24 P
B
RCA Connector Connects to the component video source
3
25
COMP In
Y RCA Connector
26 Remote Terminal Block Connects to a dry contact switch (see section 5.1)
27 12 VDC +12V DC connector for powering the unit
1 See section 6.2.2
2 The audio source is automatically detected and selected. The default selection is the audio signal embedded in the HDMI
signal. If this is not present, then the machine uses the audio from the analog input
3 For component video, connect all three connectors: Y, Cb, Cr (also known as YUV)