User`s guide

74
Compool/EasyTouch Pool and Spa Control System Upgrade Installation and User’s Guide
Installing the Compool/EasyTouch Upgrade Control Panel
(Compool Load Center with sub-panel)
To install the Compool/EasyTouch control panel:
1. Hold the transformer assembly to allow the control panel to be mounted, then slide the control panel
onto the load center hinges.
2. Mount the transformer assembly in position. Reuse the four mounting screws to secure the
transformer assembly.
3. Connect all the necessary connectors to the EasyTouch circuit board. For connector locations, see
“Compool/EasyTouch Upgrade Circuit board Wiring Diagram” on page 76.
Note: If replacing the transformer, continue with “Installing the Compool/EasyTouch
Transformer in a Compool Load Center (with sub-panel)” below.
4. Close the control panel and tighten the retaining screw.
5. Place the front door on its hinges. Tighten the hinge nut.
6. Close the front door and close the latch.
Installing the Compool/EasyTouch Upgrade Transformer in a Compool Load Center (with sub-
panel)
For Compool CP2000 and older systems the existing transformer is removed and replaced with the
transformer included with the Compool/EasyTouch Upgrade with Transformer Kit (P/N 521247). Otherwise,
CP3xxx systems require P/N 521107. See page 70. The new transformer (3 wires) supplies the correct
power for the EasyTouch circuit board. Remove the old transformer along with the attached terminal block
and wires and discard. The transformer can be configured for 115 VAC or 230 VAC input power (as shown
on page 75).
Switch the main AC power OFF to the Compool power center
Compool power center (without breaker sub-panel)
Transformer
assembly
retaining
screws
(4x)
Control panel
retaining
screw
Control
panel/plate
upper hinge
Control
panel/plate
lower hinge
Service panel
retaining screw
(high voltage
compartment)
Service panel
retaining screw
Service panel
retaining screw
F
VALVES
HEATER SOLAR
FILTER
PUMP
MODE
MODES OF OPERATION
Auto:
Indoor control panel and other remote devices operate system.
Service: Service buttons on this panel operate system.
Other remote devices are disabled.
Time Out: Service buttons on this panel operate equipment for
three hours, then settings return to Auto mode.
V
Pool
Spa
Fill (Spillway)
Drain
1
2
3
4
5
6
7
MENU SELECT
Reset
Upgrade
AUX 1
AUX 2
AUX 3
AUX 4
AUX 5
AUX 6
AUX 7
AUTO HEATER
SPA 95 F / 100 F
AIR 70 F
MON 09:30 AM