User`s guide

71
Compool/EasyTouch Pool and Spa Control System Upgrade Installation and User’s Guide
Switch the main AC power OFF to the Compool power center
To install the Compool/EasyTouch Upgrade Transformer Assembly:
1. Mount the new transformer assembly above the low voltage compartment of the power center. Route
the three (3) wires through the bushing in the high voltage barrier. See illustration on page 72.
2. Reuse the four mounting screws to secure the transformer assembly.
3. In the high voltage compartment, affix the wiring labels (included) either side of the “blue terminal
block” and connect the wires are shown below. Note: You will need to cut the new labels to fit over
the existing labels.
4. Mount the new “BLUE TERMINAL BLOCK” (included) onto the mounting rail in the high voltage
compartment of the load center. Press down to snap in place. Reconnect wiring for the transformer
and input AC power.
5. In the low voltage compartment, plug the transformer assembly cable into the socket at the top of the
Compool/EasyTouch circuit board. See “Compool/EasyTouch Upgrade Circuit board Wiring
Diagram” on page 76.
6. Mount the service panel over the high voltage compartment and secure with the three screws.
High voltage compartment
Wiring from
transformer
SYSTEM POWER
(INPUT)
Affix wiring label
Affix wiring label
TERMINAL
BLOCK
Transformer screws (4)
➁
➂
➀
➁
➂
115 VAC 230 VAC
▲
▲
▲
▲
➀
YELLOW
VIOLET
BLACK
▲
▲
▲
F
VALVES
HEATER SOLAR
FILTER
PUMP
MODE
MODES OF OPERATION
Auto:
Indoor control panel and other remote devices operate system.
Service: Service buttons on this panel operate system.
Other remote devices are disabled.
Time Out: Service buttons on this panel operate equipment for
three hours, then settings return to Auto mode.
V
Pool
Spa
Fill (Spillway)
Drain
1
2
3
4
5
6
7
MENU SELECT
Reset
Upgrade
AUX 1
AUX 2
AUX 3
AUX 4
AUX 5
AUX 6
AUX 7
AUTO HEATER
SPA 95 F / 100 F
AIR 70 F
MON 09:30 AM