User`s guide

70
Compool/EasyTouch Pool and Spa Control System Upgrade Installation and User’s Guide
Removal/Replacement of Compool Power Center Transformer Assembly:
For Compool CP2000 and older systems remove the existing Compool transformer and replace it with the
transformer in the Compool/EasyTouch Upgrade with Transformer Kit (P/N 521247).
To remove and replace the Compool power center transformer assembly:
1. Remove the four (4) screws securing the transformer assembly. Save the screws for reinstallation.
Leave the transformer assembly in place.
a) Remove the three (3) screws securing the service panel to expose the high voltage compartment in
the right side of the load center.
b) Disconnect the transformer wire and the main input AC power wires from the BLUE TERMINAL
BLOCK located in the high voltage compartment of the power center.
c) Remove the terminal block by lifting the tab on the right side of the block. Remove the terminal block
and the transformer with attached wires from the power center.
2. To replace the Compool/EasyTouch upgrade transformer kit), see page 71.
Switch the main AC power OFF to the Compool power center
Compool power
center high voltage
compartment
Remove transformer wires from
TERMINAL BLOCK
To remove TERMINAL BLOCK,
Lift tab on right side.
Compool power center
Transformer screws (4)