User`s guide

13
Compool/EasyTouch Pool and Spa Control System Upgrade Installation and User’s Guide
Section 2
Setting up Compool/EasyTouch Upgrade System
Setting up the Compool/EasyTouch Upgrade System for the First Time
Use the following steps to setup up the Compool EasyTouch Upgrade system for the first time.
1. Set the system date and time (page 31)
Set the current date and time.
2. Assign circuit names (pages 37)
Assign the generic default circuit names for output auxiliary equipment. Rename (if necessary) and assign
circuit names to the auxiliary (AUX 1, AUX 2) connections. Note the factory set auxiliary names correspond
to the plug-in location of the relay on the EasyTouch motherboard. Assign circuit names from the available of
circuit names. There are nearly 100 circuit names available (see page 38 for the complete list).
3. Creating custom names for auxiliary circuits (page 41)
If you cannot find a circuit name that fits your application you can create up to 10 additional customized
names that can be created before assigning circuit names.
4. Assign a “Circuit Function” to a “Circuit Name” (Page 39)
Assign “Circuit Functions” to circuits. From the Circuit Function” menu (page 39), you can assign special logic
to a circuit by selecting one of the available circuit functions. For the complete list of preset Circuit Functions
see page 40. If an auxiliary circuit (AUX) is assigned GENERIC (simple ON/OFF when the button is pushed)
then nothing needs to be done.
5. Configure valve actuators (controlled by AUX circuit) (page 41)
The EasyTouch system can drive two auxiliary valve actuators for applications such as solar heating and
water features. Assign which circuits that will activate valves A and B. Auxiliary valve actuators can be
controlled by any AUX circuit. Valve A is automatically assigned to solar if “Solar” is enabled in the “Solar”
menu.
6. Set up optional equipment, solar, two-speed pump (page 42)
Set up additional equipment such as solar, 2-speed pump, and optional equipment if required. Set up the control
panel to operate with the optional IntelliChlor chlorine generator (see page 35). To configure EasyTouch for
special equipment:
• Is solar heating available? Is solar being used for a heat pump?
• What circuits will turn 2-Speed pumps to High Speed?
• Cool-down cycle for the heater - Lets you set circuits that switch the filter pump to high speed.
• Do you want to delay turning off the filter pump for 10 minutes when the heater is turned off?
• Do you want the spa to heat whenever the Spa button is pressed?