User`s guide

6
Compool/EasyTouch Pool and Spa Control System Upgrade Installation and User’s Guide
iS4 Spa-Side Remote Controller (Optional)
The iS4 Spa-Side remote controller is a double-
insulated, waterproof device that is UL (1563)
listed for installation at the water’s edge.
Pentair recommends that the iS4 always be
installed above the water line of the spa wall, or
in the deck within arm’s reach of a spa
occupant. The iS4 provides remote switching of
up to four control circuits from the spa location.
It is typically used for activating spa circulation
and any three auxiliary pieces of equipment
(such as lights, jet pump, air blower, etc.). The
red status LED indicator glows steady when in
Spa mode and flashes while the spa is heating.
For more about assigning circuits to the iS4
buttons, refer to “Settings Menu: iS4 Spa-Side
Remote controller,” on page 44. The iS4 two
installation choices are shown below:
QuickTouch
®
QT4 Wireless Controller (Optional)
The QuickTouch QT4 wireless remote controller provides switching of up to
four circuits. You can use the QT4 wireless controller to activate the spa
circulation, and for operating three auxiliary pieces of equipment (such as lights,
jet pump, air blower, waterfall, etc.). Each of the four functions on the QT4
wireless controller has an on and an off button. For more about assigning
circuits to the QT4 buttons, refer to “Settings Menu: QuickTouch (QT4)
Wireless Remote,” on page 47.
IMPORTANT: The QT4 wireless controller may be used with wet hands,
but should never be submersed in water as this could damage the QT4. If
accidental submersion occurs, dry the QT4 out by removing battery cover
and removing battery. Position the QT4 so that water can drain out.
Reassemble when the QT4 is completely dry.
QuickTouch (QT4) Wireless
Remote Controller (P/N 520148)
iS4 Spa-Side Remote
Controller (Wall or tile
mount)
iS4 Spa-Side Remote
Controller (Deck
mount)
1
2
3
4
Red power LED
indicator
3
2
1
Red power
LED indicator
4
iS10 Spa-Side Remote Controller (Optional)
An iS10 Spa-Side remote controller can control up to ten functions
including a spa temperature adjustment. The iS10 Spa-Side remote
controller is listed UL (1563) for use with the EasyTouch systems at the
water’s edge. Five (5) in-line buttons control up to ten (10) system
functions numbered one through five from left to right. The middle
peanut-shaped button toggles between the top and bottom row of
buttons. The iS10 includes an LED display shows the current spa water
temperature. The spa temperature may be increased or decreased by
pressing the up or down arrow button located under the display. The
temperature display will blink while being changed. After setting the desired temperature, the display will return
to steady and show the actual temperature as it meets the set point. The temperature set by the iS10 is only
temporary. When the Spa mode is switched OFF, the temperature set at the EasyTouch control panel will
resume the next time the spa mode is activated (see “Man Heat” on page 48). The Spa Mode will automatically
turn off after 24 hours. For iS10 setup and configuration information, see page 45.
iS10 Spa Side Remote
Controller (P/N 520149)