Operating instructions

33
Compool Cp3800
Power Center
Equipment keys
Located at the equipment pad, the Power Center provides manual-override capability of your
equipment.
Caution
To prevent water damage, close Power Center door after use.
The Auto/Service key toggles the Power Center between the following
modes.
Spa
Fill
Drain
Filter
Pump
Heater
Compool Lx3800
Power Center for Cp3800 pool/spa control system
6
5
4
3
2
1
S
P
Solar
Auto
Service
IMPORTANT: Switch back to
Auto after servicing equipment.
Water Sensor
Solar Sensor
Sensor
Status
Auto
Auto
Service
Press Filter key 2 times quickly.
Filter Pump On:
Press
Filter key 3 times quickly.
Filter Pump Off:
To cancel:
The 3-hour override can be
cancelled by switching to
Service, and then back to Auto.
Make sure the Auto/Service
key is in the Auto position.
Override Verification:
The Auto lamp will blink
during the 3-Hour Override.
Instructions:
When adding chemicals to the pool,
the filter pump can be set to stay on
for 3 hours -or- stay off for 3 hours.
This overrides the programming of
the Cp3800 indoor controller on a
one-time basis. The same procedure
can be used on the other equipment
keys 1-7.
3 Hour Filter Override
P
P
▲
▲
7
Freeze Sensor
Lamp ON indicates problem with the
sensor or wires leading to sensor.
Check connections and replace sensor
if necessary.
▲
▲
▲
▲