Operating instructions

23
Compool Cp3800
Configuration Switches
After setting configuration switches, turn system power off for a few seconds.
FREEZE
Freeze settings are used to configure the following equipment.

FLTR Activate filter pump during freezing conditions.

AUX1 Activate AUX1 during freezing conditions.

AUX2 Activate AUX2 during freezing conditions.

AUX3 Activate AUX3 during freezing conditions.

AUX4 Activate AUX4 during freezing conditions.

AUX5 Activate AUX5 during freezing conditions.

AUX6 Activate AUX6 during freezing conditions.

AUX7 Activate AUX7 during freezing conditions.
I/L - Interlock
Interlock settings are used to configure the following equipment.

SPA Activate filter pump (single pump system)

CLNR Activate cleaner interlocks. Cleaner must be installed on AUX1.

FDEL Activate filter delay (heater cool down).
SYST - System
System settings are used to configure the following equipment.

SOLR Activate solar system.

HTPMP Activate heatpump as secondary heat source.

MANHT Activate heater when spa is manually turned on.

WFAL Activate an overflow from spa to pool. Uses AUX2 circuit.

FLRCL Activate floor cleaner valve.
SPEC FUNCT - Special Functions
Special Functions settings are used to configure the following equipment.

DIM3 Activate dimmer for AUX3 circuit.

DIM4 Activate dimmer for AUX4 circuit.
12345
67
ON
8
12345
67
ON
8
12345
67
ON
8
1234
ON
FLTR AUX1 AUX2 AUX3 AUX4 AUX5 AUX6 AUX7
FREEZE I/L SYST SPEC FUNCT HI SPD
SPA
POOL
HEAT
SPA CLNR FDEL SOLR HTPMP MANHT WFAL FLRCL DIM3 DIM4 A7BW A730 SPA HTR AUX1 SOLR
PHONE CONTROLS