Service manual

Ultraview 1030/1050 Monitors — Service Manual
4-18
Display or Touchscreen Assembly Replacement
Removing the Bezel
Figure 4-10: Bezel removal
Note:
The handle assembly may remain attached to the rear housing. Access holes are present in
the handle enclosure to gain access to the Front Bezel fastening screws.
1 Remove the expansion housing, if present.
2 Remove the four 6-32 × 1 1/4 inch screws from the top rear housing.
3 Remove the four 6-32 × 3/8 inch screws along the bottom rear housing.
Note:
Due to the short length of the inverter cable, remove it prior to fully opening the case.