Service manual

Ultraview 1030/1050 Monitors — Service Manual
4-15
Maintenance
Replacing the Interconnect PCBA and Frame
1 Remove the chassis assembly from the housing as previously described.
2 Separate the chassis assembly from the module wall assembly by removing the two screws
above the battery ejection springs and the two screws near the bottom.
Figure 4-7: Replacing the interconnect PCBA and frame
3 Remove the screw between the chassis and the interconnect PCBA.
4 Separate the interconnect PCBA and frame.
5 Reassemble the monitor in reverse order.
interconnect PCBA