Service manual

Ultraview 1030/1050 Monitors — Service Manual
2-19
Setup
RECORDER NAMES Key
The RECORDER NAMES key enables you to assign names to each recorder on the system.
Touching RECORDER NAMES displays the following information:
When touched, the Keyboard menu appears (refer to Figure 2-6 on page 2-15), enabling you to
enter or change the name. Each name can contain from one to five characters.
To change a recorder name:
1 Touch the recorder key that you want to change or touch a blank key to add another recorder.
2 Enter the name of the recorder.
3 When you have entered the name correctly, touch ENTER to store the name into memory.
SELECT RECORDERS Key
The SELECT RECORDERS key enables you to assign a priority to system recorders for each bed.
Touching this key displays the following menu:
Caution:
The AUTO selection considers paper usage in determining the destination of the
recording. The BACKUP selection always selects the PRIMARY recorder, unless it is
either unavailable or unable to print recording.
1 Touch one of the above keys to display a list of available system recorders.
2 Touch the recorder name key assigned to the bed as either primary or backup (depending upon
your choice in step 1).
3 Touch PREVIOUS MENU to return to one of the Select Priority menus.
4 Repeat steps 1 through 3 to assign the remaining recorder(s).
(The bed names are provided as examples.)
Select recorder name to change
REC01 REC02 REC03 REC04 CENT1 ICU02 ER
PRIMARY
Select priority of recorder to be assigned to xxxxx
BACKUP
(when the SELECTION key is set to BACKUP)
RECORDER BRECORDER A
Select priority of recorder to be assigned to xxxxx
(when the SELECTION key is set to AUTO)
(where xxxxx is the bedname)