Service manual

Ultraview 1030/1050 Monitors — Service Manual

2-16

Biomed Setup Keys

NETWORK SETUP Key

The Network Setup key enables you to define a subnet name, node ID, and bed name; view the

active nodes on the network and select an appropriate subnet access level. Touch NETWORK

SETUP to display the following menu:

SUBNET Key

Touch SUBNET to display the Keyboard menu that enables you to key in a subnet name (refer to

Keyboard Menu on page 2-15 for instructions on use). This name can contain up to five

characters, letters, or numbers.

To enter a subnet name:

1 Touch SUBNET.

2 Type in the subnet name.

3 When you have entered the name correctly, touch ENTER to store the name in memory.

4 Reset the monitor so that the network can recognize the new name.

NODE ID Key

Touch the NODE ID key to display the pop-up keyboard (refer to Figure 2-6 on page 2-15).

Each monitor on the network must have a unique node ID. The default node ID for an un-initialized

monitor is 1. You must change this ID to allow the monitor to function properly on the network.

After changing the ID, you must reset the monitor to enable the system to recognize the new node

ID.

To enter a node ID:

1 Touch NODE ID.

2 Enter a number between 1 to 64 (1 to 250 with monitors that support the Expanded Network).

3 When you have entered the Node ID correctly, touch ENTER on the keypad to store the value

in memory.

4 Reset the monitor so that the network recognizes the new Node ID.

NODE