Service manual

Ultraview 1030/1050 Monitors — Service Manual
2-11
Setup
Ethernet Cable
Bulk Cables
If desired, cables can be constructed from bulk 500 foot (152.4 meters) spools keeping in mind
cables are 326 feet (100 meters) maximum. This type of cable construction would be preferable in
cases where conduit lengths are unknown.
SDLC Cable Interconnection
A 9-pin connector with ferrite beads must be used. Refer to the Module Housings and Power
Supplies Service Manual (P/N 070-0680-xx), located on CD-ROM 084-0700-xx.
Software Configuration
The Biomed menu enables an authorized service representative to set user defaults for monitor
operation. To access the Biomed menu:
1 Press MONITOR SETUP.
1 Touch PRIVILEGED ACCESS to display the Keyboard menu.
MONITOR SETUP
TONES
ADMIT/
DISCH.
MONITOR
SETUP
MONITOR
CONFIG.
RECORDER
CONFIG.
OUTBOUND
PARAMETERS
PRIVILEGED
ACCESS