Service manual

Ultraview 1030/1050 Monitors — Service Manual
2-7
Setup
Installing the Optional Recorder Assembly
Caution:
Unless purchased separately for a monitor already in the field, the recorder option is
installed at the factory. Order an upgrade from your local Sales Representative.
The recorder option is comprised of two components: the recorder module and the recorder CPU
PCBA.
The recorder CPU PCBA and recorder module fit into the upper slot on the left side of the monitor
(refer to Figure 2-4). The recorder CPU PCBA must be installed first, followed by the recorder
module.
1 To install the recorder CPU PCBA (P/N 670-0625-00), power OFF the monitor, open the printer
door, remove recorder hold cover, and insert the recorder CPU into the connector located at
the bottom of the recorder compartment. After fully inserting the PCBA into the connector,
tighten the thumbscrew to secure it to the bottom of the recorder compartment.
2 Install the insulator sheet.
3 Insert the recorder assembly (P/N 050-0064-00), ensuring that it fully engages the connector at
the back of the recorder compartment. Press the release bar to open the recorder assembly.
Tighten the two captive screws.
Figure 2-4: Recorder assembly and CPU
recorder
CPU PCBA
recorder
assembly
thumb
the recorder assembly to load paper
screw
press the release bar to open