Setup Guide
Attaching the camera:
Once you've identified the location to install the camera, then:
1. Drill the turret hole using the hole saw. This should go all the way through the Duraplate
leaving a clean through-hole.
2. Insert the Bracket Placement Spacer into the hole. It should seat comfortably flat on the
trailer surface.
3. Peel the cover layer pieces off the double-stick tape on the back side of the bracket, and
taking care to keep the bracket vertically oriented, press the bracket firmly against the trailer
to set the tape.
4. Using the 3/16” drill bit, drill out the 8 rivet holes.
5. Using the rivet tool, set the 8 rivets in the holes.
6. CRITICAL: Before installing the camera in the bracket, write down/record the device ID. This is
located on the front transparent housing, just above the camera turret. The ID should start
with “SKYCAM”. This ID will be needed for the BLE pairing to the Hub/Gateway.
7. Place the camera in the bracket and attach the 4 security screws using the 5/32" Pin-in-Hex
Security Bit.