Setup Guide
4. Select “New Beacon Install”
5. Enter Container details
6. When prompted, scan the QR Code on the Beacon that was installed
7. Click “Activate Beacon”
The container and beacon are now paired, visible in Compology’s asset tracking web app, and
can be detected by the Compology Beacon Finder app (that should already be downloaded and
running on your truck android tablets and phones).
Disclaimer:
NOTICE:
This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
1. l'appareil ne doit pas produire de brouillage, et
2. l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
NOTICE:
Changes or modifications made to this equipment not expressly approved by Compology may void the FCC
authorization to operate this equipment.
As in FCC / ISED RSS-102 standards, to comply with FCC RF exposure requirements for mobile transmitting devices,
this device shall be installed to provide a separation distance of 20cm (~8 inches) or more from all persons
And the transmitters on this device do not transmit simultaneously.