Specifications

Chapter 4 Common Configuration
36
4.4.1.3 Tag VLAN - [Available in Access Point mode ONLY]
While a port-based VLAN is limited in size since it can only exist within the
confines of a single Ethernet switch, a Tag VLAN is designed to extend the
wired VLAN to individual wireless clients.
Here, each VLAN is identified by a ‘tag’, which the switch associates with
specific ports. The switch will then pass this tag information with every data
packet transmitted. By using the same tag on each access point in the network,
full client roaming can be implemented while complying with VLAN
integrity.
Wireless Pseudo VLAN – Tag VLAN
From WLAN Setup under Configuration, click on Advanced, which shows the WLAN
Advanced Setup page.:
Go to the Extended Features
section.
Click on the Access Control button.
The Wireless Pseudo VLAN
function is Disabled by default.
Select Tag VLAN from the drop-
down list.
Click on the Apply button.
The Tag VLAN page enables you to manage specific VLAN groups by adding or deleting
clients through their MAC address.