Specifications

Chapter 4 Common Configuration
18
This table describes the parameters that can be modified in the Management Port
Setup page.
Parameters Description
IP Address
The IP address of Compex WPE54AG is set by default to
192.168.168.1.
Network Mask
The Network Mask serves to identify the subnet in which Compex
WPE54AG resides. The default network mask is 255.255.255.0.
DHCP Start IP
Address
This is the first IP address that the DHCP server will assign. The
value that you input here should belong to the same subnet as
Compex WPE54AG. For example, if the IP address and network
mask of your Compex WPE54AG are 192.168.168.1 and
255.255.255.0 respectively, the DHCP Start IP Address should be
192.168.168.X, where X can take any value from 2 to 254. This value
is pre-set to 192.168.168.100.
DHCP End IP
Address
This is the last IP address that the DHCP server can assign. It should
also belong to the same subnet as Compex WPE54AG. For instance,
if the IP address and network mask of your Compex WPE54AG are
192.168.168.1 and 255.255.255.0 respectively, the DHCP End IP
Address should be 192.168.168.X, where X can take any value from
2 to 254. It is pre-set as 192.168.168.254.
DHCP Gateway IP
Address
Inserting a DHCP gateway IP address will enable the DHCP server to
automatically assign an IP address to any PC belonging to a different
subnet or LAN.
Always use these
DNS servers
If this checkbox is enabled, the DHCP server will also resolve the
DNS queries of the computers. Otherwise, you will have to set up
DNS information manually for every PC in your network.
Primary DNS IP
Address
Your ISP usually provides the IP address of the DNS server.
Secondary DNS IP
Address
This optional field is reserved for the IP address of a secondary DNS
server.
DHCP Server
If you disable the DHCP server, you will need to manually configure
the TCP/IP parameters of each PC in your network.