Install guide

ManualsBrandsCompex ManualsNetworkingWPE54

Quick Install Guide

Compex Wireless

Network Access

Point

WPE54

Version 1.1

1. Introduction

This compact and high-performance access point is designed with

support for high security features like enhanced Wi-Fi Protected

Access (WPA1/2-PSK, WPA1/2-EAP), IEEE 802.1x Authentication

(TLS, TLLS, PEAP, EAP-SIM) and 64-bit or 128-bit Wired

Equivalent Privacy.

Exclusive wireless LAN technology Wireless Pseudo VLAN further

enhances security in wireless hotspot networks in isolating different

users into their own VLANs.

The access point is capable of operating in 6 different modes: Access

Point Bridging, Access Point Client, Gateway, Wireless Routing

Client, Wireless Ethernet Adapter and Wireless Bridge Link, making

it suitable for all kinds of wireless applications.

2. Hardware Installation

1. Connect one end of a RJ45 crossover Ethernet cable to your PC

and the other end to the Ethernet port of the access point.

2. Next, attach the power adapter supplied in the packaging to the

power point.

3. Connect the power plug into the DC jack of the access point.

4. Power ON the access point and your PC. Notice that the LAN

Link/ACT and Power LEDs will light up. This indicates that

the connection has been established successfully between the

access point and your PC.

NETPASSAGE

Summary of content (4 pages)

PAGE 1
NETPASSAGE 1. Introduction Quick Install Guide Compex Wireless Network Access Point WPE54 Version 1.1 This compact and high-performance access point is designed with support for high security features like enhanced Wi-Fi Protected Access (WPA1/2-PSK, WPA1/2-EAP), IEEE 802.1x Authentication (TLS, TLLS, PEAP, EAP-SIM) and 64-bit or 128-bit Wired Equivalent Privacy.
PAGE 2
3. Access to Web-based Interface Now, the access point acts as a DHCP Server that can assign IP address to your PC/clients. The powerful uConfig utility has been developed which provides you hassle-free access to the web-based configuration page. To do so, simply 1. 2. 3. Insert your Product CD into your CD-ROM drive. Go to the Utilities section. Click uConfig to run the program. The following screen shot will appear.
PAGE 3
4. Select the radio buttons for Obtain an IP address automatically and Obtain DNS server address automatically. Click on the OK button to update the changes. Next, you may set up Windows XP’s Wireless Network Connection as follows: 5. 6. Right click on Wireless Network Connection corresponding to the Wireless Ethernet Adapter you wish to connect to the access point, and click on Properties. Go to Wireless Networks tab and click on Add.. button. 7.
PAGE 4
7. Panel Views and Descriptions Disclaimer: Compex, Inc. provides this guide without warranty of any kind, either expressed or implied, including but not limited to the implied warranties of merchantability and fitness for a particular purpose. Compex, Inc. may make improvements and/or changes to the product and/or specifications of the product described in this guide, without prior notice. Compex, Inc will not be liable for any technical inaccuracies or typographical errors found in this guide.