Install guide

Chapter 2 Let’s Get Going - Hardware Setup
5
Method Two: Using Compex PoE to supply power to the unit
Compex Power-Over-Ethernet (PoE) is fully compatible with our Compex
WP54G. This accessory supplies operational power to the wireless AP via the
Ethernet cable connection.
Users who have already purchased the Compex PoE and who wish to use it to
supply power to the Compex WP54G may follow the installation procedures as
shown below:
Connect the external antenna to the SMA
connector of Compex WP54G.
Use an RJ45 Ethernet cable to connect one end of the cable to the Ethernet
socket of the Injector and the other end to one of the LAN ports of Compex
WP54G.
Warning:
When one port is used for PoE, the other port cannot connect to any other
network device.
Maximum length of the RJ45 Category 5 cable is 100 metres.