User guide
Table Of Contents
- 3Com Wireless 8760 Dual-radio 11a/b/g PoE Access Point
- Contents
- Introduction
- Installing the Access Point
- Installation Requirements
- Power Requirements
- Safety Information
- Deciding Where to Place Equipment and Performing A Site Survey
- Before You Begin
- Connecting the Standard Antennas
- Connecting Power
- Checking the LEDs
- Wall, Ceiling, or Electrical Box Mounting
- Flat Surface Installation
- Selecting and Connecting a Different Antenna Model
- Installing Software Utilities
- Initial Configuration
- System Configuration
- Command Line Interface
- Using the Command Line Interface
- General Commands
- System Management Commands
- System Logging Commands
- System Clock Commands
- DHCP Relay Commands
- SNMP Commands
- snmp-server community
- snmp-server contact
- snmp-server location
- snmp-server enable server
- snmp-server host
- snmp-server trap
- snmp-server engine-id
- snmp-server user
- snmp-server targets
- snmp-server filter
- snmp-server filter-assignments
- show snmp groups
- show snmp users
- show snmp group-assignments
- show snmp target
- show snmp filter
- show snmp filter-assignments
- show snmp
- Flash/File Commands
- RADIUS Client
- 802.1X Authentication
- MAC Address Authentication
- Filtering Commands
- WDS Bridge Commands
- Spanning Tree Commands
- Ethernet Interface Commands
- Wireless Interface Commands
- interface wireless
- vap
- speed
- turbo
- multicast-data-rate
- channel
- transmit-power
- radio-mode
- preamble
- antenna control
- antenna id
- antenna location
- beacon-interval
- dtim-period
- fragmentation-length
- rts-threshold
- super-a
- super-g
- description
- ssid
- closed-system
- max-association
- assoc-timeout-interval
- auth-timeout-value
- shutdown
- show interface wireless
- show station
- Rogue AP Detection Commands
- Wireless Security Commands
- Link Integrity Commands
- IAPP Commands
- VLAN Commands
- WMM Commands
- Troubleshooting
- Index
4
3 Initial Configuration
Networks with a DHCP Server 3-1
Networks without a DHCP Server 3-1
Using the 3Com Installation CD 3-2
Launch the 3COM Wireless Infrastructure Device Manager (Widman)
utility 3-2
Launching the 3com Wireless Interface Device Manager 3-2
First Time Only 3-4
Using the Setup Wizard 3-4
4 System Configuration
Advanced Setup 4-2
System Identification 4-4
TCP / IP Settings 4-5
RADIUS 4-8
Authentication 4-9
Filter Control 4-14
VLAN 4-16
SNMP 4-18
Configuring SNMP and Trap Message Parameters 4-18
Configuring SNMPv3 Users 4-21
Administration 4-22
Changing the Password 4-22
Telnet and SSH Settings 4-23
Upgrading Firmware 4-24
WDS and Spanning Tree Settings 4-27
System Log 4-33
Enabling System Logging 4-33
Configuring SNTP 4-34
Radio Interface 4-35
802.11a Interface 4-36
Configuring Radio Settings 4-36
Configuring Common Radio Settings 4-38
802.11b/g Interface 4-42
Configuring Wi-Fi Multimedia 4-44
Security 4-49
Wired Equivalent Privacy (WEP) 4-52