User guide
Table Of Contents
- 3Com Wireless 8760 Dual-radio 11a/b/g PoE Access Point
- Contents
- Introduction
- Installing the Access Point
- Installation Requirements
- Power Requirements
- Safety Information
- Deciding Where to Place Equipment and Performing A Site Survey
- Before You Begin
- Connecting the Standard Antennas
- Connecting Power
- Checking the LEDs
- Wall, Ceiling, or Electrical Box Mounting
- Flat Surface Installation
- Selecting and Connecting a Different Antenna Model
- Installing Software Utilities
- Initial Configuration
- System Configuration
- Command Line Interface
- Using the Command Line Interface
- General Commands
- System Management Commands
- System Logging Commands
- System Clock Commands
- DHCP Relay Commands
- SNMP Commands
- snmp-server community
- snmp-server contact
- snmp-server location
- snmp-server enable server
- snmp-server host
- snmp-server trap
- snmp-server engine-id
- snmp-server user
- snmp-server targets
- snmp-server filter
- snmp-server filter-assignments
- show snmp groups
- show snmp users
- show snmp group-assignments
- show snmp target
- show snmp filter
- show snmp filter-assignments
- show snmp
- Flash/File Commands
- RADIUS Client
- 802.1X Authentication
- MAC Address Authentication
- Filtering Commands
- WDS Bridge Commands
- Spanning Tree Commands
- Ethernet Interface Commands
- Wireless Interface Commands
- interface wireless
- vap
- speed
- turbo
- multicast-data-rate
- channel
- transmit-power
- radio-mode
- preamble
- antenna control
- antenna id
- antenna location
- beacon-interval
- dtim-period
- fragmentation-length
- rts-threshold
- super-a
- super-g
- description
- ssid
- closed-system
- max-association
- assoc-timeout-interval
- auth-timeout-value
- shutdown
- show interface wireless
- show station
- Rogue AP Detection Commands
- Wireless Security Commands
- Link Integrity Commands
- IAPP Commands
- VLAN Commands
- WMM Commands
- Troubleshooting
- Index
3
Contents
1 Introduction
Product Features 1-2
Security 1-2
Performance and Reliability 1-3
Virtual Access Point (VAP) Support 1-3
WDS Bridging and Spanning Tree Protocol (STP) Support 1-3
Manageability 1-4
Wireless Network Standards 1-4
802.11g 1-4
802.11a 1-5
Approved Channels 1-5
2 Installing the Access Point
Installation Requirements 2-1
Power Requirements 2-2
Safety Information 2-2
Deciding Where to Place Equipment and
Performing A Site Survey 2-3
Before You Begin 2-4
Connecting the Standard Antennas 2-5
Connecting Power 2-6
Using the Power Supply 2-8
Using a Power-Over-Ethernet LAN Port 2-8
Checking the LEDs 2-9
Reset Button 2-9
Wall, Ceiling, or Electrical Box Mounting 2-10
Flat Surface Installation 2-12
Selecting and Connecting a Different Antenna Model 2-12
Installing Software Utilities 2-14