User guide
Table Of Contents
- 3Com Wireless 8760 Dual-radio 11a/b/g PoE Access Point
- Contents
- Introduction
- Installing the Access Point
- Installation Requirements
- Power Requirements
- Safety Information
- Deciding Where to Place Equipment and Performing A Site Survey
- Before You Begin
- Connecting the Standard Antennas
- Connecting Power
- Checking the LEDs
- Wall, Ceiling, or Electrical Box Mounting
- Flat Surface Installation
- Selecting and Connecting a Different Antenna Model
- Installing Software Utilities
- Initial Configuration
- System Configuration
- Command Line Interface
- Using the Command Line Interface
- General Commands
- System Management Commands
- System Logging Commands
- System Clock Commands
- DHCP Relay Commands
- SNMP Commands
- snmp-server community
- snmp-server contact
- snmp-server location
- snmp-server enable server
- snmp-server host
- snmp-server trap
- snmp-server engine-id
- snmp-server user
- snmp-server targets
- snmp-server filter
- snmp-server filter-assignments
- show snmp groups
- show snmp users
- show snmp group-assignments
- show snmp target
- show snmp filter
- show snmp filter-assignments
- show snmp
- Flash/File Commands
- RADIUS Client
- 802.1X Authentication
- MAC Address Authentication
- Filtering Commands
- WDS Bridge Commands
- Spanning Tree Commands
- Ethernet Interface Commands
- Wireless Interface Commands
- interface wireless
- vap
- speed
- turbo
- multicast-data-rate
- channel
- transmit-power
- radio-mode
- preamble
- antenna control
- antenna id
- antenna location
- beacon-interval
- dtim-period
- fragmentation-length
- rts-threshold
- super-a
- super-g
- description
- ssid
- closed-system
- max-association
- assoc-timeout-interval
- auth-timeout-value
- shutdown
- show interface wireless
- show station
- Rogue AP Detection Commands
- Wireless Security Commands
- Link Integrity Commands
- IAPP Commands
- VLAN Commands
- WMM Commands
- Troubleshooting
- Index

I-2
G
gateway address 4-6, 5-2, 5-99
H
hardware version, displaying 5-27
HTTP, secure server 5-21
HTTPS 5-21
I
IAPP 5-144
IEEE 802.11a 4-35, 5-104
configuring interface 4-36, 5-104
maximum data rate 5-107
radio channel 5-108
IEEE 802.11b 4-35
IEEE 802.11f 5-144
IEEE 802.11g 4-35
configuring interface 4-42, 5-104
maximum data rate 5-107
radio channel 4-44, 5-108
IEEE 802.1x 4-56, 5-70, 5-76
configuring 4-10, 5-70
IEEE 802.3af power-over-Ethernet 2-6
initial setup 3-1
installation 2-1
access point 2-1
antenna 2-5
cable 2-1
flat surface 2-12
location 2-3
power 2-2
requirements 2-1
software utilities 2-14
wall mount 2-12
IP address
BOOTP/DHCP 5-99, 5-100
configuring 3-9, 4-5, 5-99, 5-100
troubleshooting 6-2
L
LEDs 2-9
location
for installation 2-3
log
messages 4-34, 4-61, 5-33
server 4-33, 5-33
login
CLI 5-1
web 3-5
logon authentication
RADIUS client 4-13, 5-64
M
MAC address
recording 2-4
MAC address, authentication 4-11, 5-76, 5-77
maximum associated clients 4-40
maximum data rate 5-107
802.11a interface 5-107
802.11g interface 5-107
O
open system 3-9, 4-49, 5-118
P
password
configuring 4-22, 5-17
management 4-22, 5-17
port priority
STA 5-96
power 2-2
connecting 2-6
requirements 2-2
supply, 3Com integrated 2-6, 2-8
power-over-Ethernet 2-6
PSK 4-57
R
radio channel
802.11a interface 5-108
802.11g interface 4-44, 5-108
configuring 3-7
RADIUS 4-8, 4-56, 5-64
RADIUS, logon authentication 4-13, 5-64
recording MAC address 2-4
Remote Authentication Dial-in User Service See
RADIUS
Request to Send See RTS
reset 4-26, 5-11
reset button 4-26
resetting the access point 4-26, 5-11
restarting the system 4-26, 5-11
RJ-45 port
configuring duplex mode 5-101
configuring speed 5-101