User guide

5-84
CHAPTER 5: COMMAND LINE INTERFACE
Example
WDS Bridge Commands
The commands described in this section are used to set the operation mode for
each access point interface and configure WIreless Distribution System (WDS)
forwarding table settings.
Table 23 WDS Bridge Commands
Enterprise AP#show filters
Protocol Filter Information
=======================================================================
Local Bridge :Traffic among all client STAs blocked
AP Management :ENABLED
Ethernet Type Filter :DISABLED
UPlink Access Table
-----------------------------------------------------------------------
UPlink access control:Enabled
UPlink MAC access control list :
00-12-34-56-78-9a
-----------------------------------------------------------------------
Enabled Protocol Filters
-----------------------------------------------------------------------
No protocol filters are enabled
=======================================================================
Enterprise AP#
Command Function Mode Page
bridge role Selects the bridge operation mode for a radio interface IC-W 5-85
bridge-link parent Configures the MAC addresses of the parent bridge
node
IC-W 5-86
bridge-link child Configures MAC addresses of connected child bridge
nodes
IC-W 5-86
bridge dynamic-entry
age-time
Sets the aging time for dynamic entries in the WDS
forwarding table
GC 5-87
show bridge aging-time Displays the current WDS forwarding table aging time Exec 5-88
show bridge filter-entry Displays current entries in the bridge MAC address
table
Exec 5-89
show bridge link Displays current bridge settings for specified interfaces Exec 5-90