Specifications

Chapter 4 Software Installation
23
After setting all configurations, reset the power supply of Compex SGX3226. A Hyper Terminal
screen will appear to list out all configurations.
Figure 4.3-5 Information on Compex SGX3226 Configuration
You can modify the configuration on the screen itself, such as changing the IP Address after you
have upgrade the firmware.
Here is the listing for commands used in Hyper Terminal:
System Commands Descriptions
sys--System Management Commands
sys show info Show system information of the device
sys show ip Show the IP Address of the device
sys show ethernet address Show Ethernet address
sys set ip <IP Address>
<Subnet Mask>
Set IP Address and Subnet Mask of the device, e.g.
sys set ip <ddd.ddd.ddd.ddd> <ddd.ddd.ddd.ddd>
sys set name "string" Give a name to the device,e.g.
SGX3226
sys set contact "string" Give a contact information to the device, e.g. Compex
sys set location "string" Give a location name to the device, e.g. Singapore
sys set password Set administrator’s password
sys set link_info <on|off> Enable or disable the link status in the Change Report, e.g.
sys set link_info on
sys check fault Check any fault occurs in Thermal, Chassis Fan, etc.