Specifications

Chapter 4 Software Installation

This chapter explains the basic setup procedures of configuring Compex SGX3226 using the web-based

interface. For more detailed information about Compex SGX3226, please refer to Chapter 7 “Advanced

Configuration for Compex SGX3226” on Page 51.

4.1 Configuration on PC settings

Each PC in the LAN must be configured in order for them to communicate with Compex

SGX3226.To do so, follow the steps shown below:

1. From your Windows 95/98/2000/NT/ME computer, click “Start” button, point to Settings,

and select Control Panel.

2. Double click the Network icon.

3. Check to see if the TCP/IP protocol is installed. If not yet, please add this protocol first before

proceeding with the next step.

4. Select TCP/IP protocol and click “Properties” button. Click on the radio button for Obtain an

IP address automatically.

5. Go to DNS Configuration tab and select Disable.

6. Select WINS Configuration tab. Click Disable WINS Resolution.

7. Hit the “Ok” button and restart your computer.

4.2 NPfind Utility Software

Npfind is an utility program for Windows which can be used to find out the IP address of

Compex’s product. To check your IP Address of Compex SGX3226,

1. Connect one end of the MDI straight cable to one of the LAN port of Compex SGX3226, and

the other end to your PC.

2. Next, insert Product CD to your CD-ROM Drive.

3. Go to DRIVERS & UTILITIES section and click on Npfind Utility Software.