Specifications

Chapter 3 Hardware Installation
16
NOTE
For proper ventilation, do allow about at least 4 inches of clearance on the
front and 4 inches on the back of the Switch. This is especially important for
enclosed rack installation.
3.1.3 Expansion Module Installation
A series of optional Expansion Modules are available for Compex SGX3226 to enhance
the features. As Compex SGX3226 supports the hot plug function, you may install or
uninstall the Modules without turning off the Switch.
1. Please note that Compex SGX3226 is shipped with the Gigabit modules.
2. Insert the Module carefully into the Expansion Module Window and push it along
the Module rail until it stops. Ensure that there is a secure connection to the PCB
Board of Compex SGX3226.
3. The Ready LED of the related port will lights up.
4. Tighten the screws on the module.
To remove Expansion Module,
1. Disconnect any cable from the Module.
2. Unscrew and pull out the Module slowly from the Expansion Module Slot.
3. Slide the Module completely out of the Chassis and cover the Window with the
cover plate, screwing back using the original screws.