Install guide

English Compex 24 Port 10/100 Mbps plus 2 Port Gigabit
Copper SNMP Managed Switch
SGX3226
15
Upon powering up Compex SGX3226, the following LEDs will start indicating their status.
(Factory Default Configurations)
Types of LEDs Status Indication
Steady Green In normal operation System Status
Steady Red Initializing or starting up
Redundant Power Socket Off No RPS is installed or RPS is in Standby
Mode.
Steady Green The alarm buzzer is disabled Mute
Off The alarm buzzer is enabled
Steady Green In normal operation Power
Steady Red Power Fault occurs
Off In normal operation Thermal Fault
Steady Red Temperature is too high
Off In normal operation Fan Fault
Steady Red Fans are not functioning well.
3. In order to connect network cables to Compex SGX3226, plug the network cable to RJ45
port of Compex SGX3226.
Note:
When connecting network devices through Ethernet cables, make sure that the right cables are
used so as to prevent malfunction.
4. The LNK/ACT LED of that particular port should light up to indicate good connection. If
not, check the cabling and connection of the devices again.