User`s guide

Chapter 6: Creating a Bootable Array ● 40
7 Review the information that is displayed.
Note:
Adaptec Storage Manager uses the term logical drives when referring to arrays (see
page 12).
In this example, Adaptec Storage Manager has used four equal-sized disk drives to
automatically create one logical drive with RAID 5 and a hot spare.
To specify a size for the logical drives, or to make other changes to the configuration, click
Modify logical devices.
8 Click Apply, then click Ye s when prompted to confirm applying your new configuration.
Adaptec Storage Manager builds the logical drive(s).
The configuration is saved on the Adaptec controller (as an “array”, see page 12) and on the
physical disk drives.
9 Partition and format your logical drive.
The logical drive you created appears as a physical disk drive on your operating system.
Yo u must partition and format these logical drives before you can use them to store data.
10 Close all windows, then click Reboot to restart your system.
11 Remove the RAID Installation CD.
For information on installing and using Adaptec Storage Manager as a full software
application, refer to the Adaptec Storage Manager User’s Guide or online Help.
12 Continue with Making Your Array Bootable on page 40.
Making Your Array Bootable
Use the ACU to make the array bootable (see Creating Bootable Arrays on page 77).
Then c
ontinue with Installing the Driver and an Operating System on page 41 .