Specifications

98 en | Terminal Operation SCSI to SATA RAID Subsystem | Administrator’s Manual
F.01U.027.802 | V1 | 2006.11 Bosch Security Systems
If the online initialization mode is applied, the logical drive will first be created and the con-
troller will find an appropriate time to initialize the array.
The completion of array creation is indicated by the message prompt above.
A controller event will then prompt to indicate that the logical drive initialization has begun.
Press [ESC] to cancel the “Notification” prompt, and a progress indicator will display on the
screen as a percentage bar.
While the array initialization runs in the background, you can start using the array or continue
configuring your RAID subsystem.
When a fault-tolerant RAID level (RAID 1, 3 or 5) is selected, the subsystem will start initializ-
ing parity.
Use the [ESC] key to view the status of the created logical drive.
Fig. 7.15 Logical Drive Status Screen
i
NOTICE!
Only logical drives with RAID levels 1, 3 or 5 will take the time to initialize the logical drive.
Logical drives with RAID level 0 and NRAID do not perform logical drive initialization; the drive
initialization will be finished almost immediately.