Specifications

SCSI to SATA RAID Subsystem | Administrator’s Manual Terminal Screen Messages | en 87
Bosch Security Systems F.01U.027.802 | V1 | 2006.11
6.7 Channel’s Status
Fig. 6.7 Channel Status Screen
Chl Channel number
Mode Channel mode
Host Host Channel mode
Drive Drive Channel mode
ID IDs managed by the Controller
* Multiple IDs were applied (Host Channel mode only)
(ID number) Host Channel:
Specific IDs managed by the Controller for host LUN mapping
Drive Channel:
Specific ID reserved for the channel processor on the Control-
ler
AUTO Channel bus data rate set to auto speed negotiation
DefSynClk Default bus synchronous clock:
??.?M The default setting of the channel is ??.? MHz in Synchronous
mode.
Async. The default setting of the channel is Asynchronous mode.
DefWid Default bus width:
Width SCSI transfer protocol
SATA As regulated by SATA specifications
S Signal:
L SCSI-320
Term Terminator Status:
On Terminator is enabled.
Off Terminator is disabled.
Diff The channel is a Differential channel. The terminator can only
be installed/removed physically.
N/A Non-SCSI bus