Specifications

SCSI to SATA RAID Subsystem | Administrator’s Manual LCD Keypad Operation | en 71
Bosch Security Systems F.01U.027.802 | V1 | 2006.11
5.12.3 Deleting a Channel ID
Press ENT for two seconds to enter the Main Menu. Press the up or down arrow keys to select
"View and Edit Channels," then press ENT.
The first host channel should appear. Press ENT to select a host channel.
Press ENT on “Set SCSI Channel ID..”
A list of host channel and host ID combinations will appear. Use the up or down arrow keys to
select an ID you wish to remove. Press ENT to select a channel ID combination.
You will then be prompted by the “Add Channel SCSI ID” option. Press the down arrow key to
proceed.
The “Delete Channel SCSI ID” option will appear. Press ENT to display the confirm box. Press
ENT for two seconds to remove the ID.
A prompt will remind you to reset the subsystem for the configuration change to take effect.
You may press ENT to reset the subsystem immediately or you may press ESC to continue add-
ing other host IDs and reset the subsystem later.
i
NOTICE!
• Every time you make changes to channel IDs, you must reset the subsystem for the con-
figuration to take effect.
• For IDs reserved in different subsystem configurations, please refer to the Installation
Manual that came with your system. For subsystems featuring back-end PCB connection,
firmware can detect their board types and automatically apply the preset IDs. There is no
need to set IDs for these models.