Specifications

40 en | Accessing the Array: Serial Port, Ethernet, and Access Security SCSI to SATA RAID Subsystem | Administrator’s Manual
F.01U.027.802 | V1 | 2006.11 Bosch Security Systems
Fig. 3.10 Set IP Address Page
Provide the IP address, NetMask, and Gateway values accordingly.
Fig. 3.11 Provide IP Address Page
PING the IP address from your management computer to make sure the link is up and
running.
3.4 Telnet Connection
1. Use an Ethernet cable with RJ-45 phone jacks to connect the Ethernet port on the sub-
system/controller module.
2. Connect the other end of the Ethernet cable to your local area network. An IP address
should be acquired for the subsystem’s Ethernet port. The subsystem firmware also sup-
ports automatic client configuration such as DHCP.
3. Consult your network administrator for an IP address that will be assigned to the sub-
system/controller Ethernet port.
4. Assign an IP address to the subsystem/controller’s Ethernet port and specify the Net-
Mask and Gateway values. Power off your system and then power on again for the config-
uration to take effect.
5. Select "View and Edit Configuration Parameters" from the main menu on the terminal
screen. Select "Communication Parameters" -> "Internet Protocol (TCP/IP)" -> press
ENTER on the chip hardware address -> and then select "Set IP Address."
6. Provide the IP address, NetMask, and Gateway values accordingly.
7. PING the IP address from your management computer to make sure the link is up and
running.
8. Open a command prompt and key in “telnet <IP address>” to access the embedded firm-
ware utility.