Specifications

SCSI to SATA RAID Subsystem | Administrator’s Manual Accessing the Array: Serial Port, Ethernet, and Access Security | en 37
Bosch Security Systems F.01U.027.802 | V1 | 2006.11
3.2.4 Internet Protocol <TCP/IP>
The Internet Protocol menu allows you to prepare the management access through the sub-
system/controller’s RJ-45 Ethernet port.
Fig. 3.6 Internet Protocol Page
To access the configuration options, press Enter on “Internet Protocol <TCP/IP>” to display
the information of Ethernet port. Press [ENTER] on the chip information to display the “View
Statistics” and the “Set IP Address” options.
3.2.5 View Statistics
Fig. 3.7 View Statistics Page
3.2.6 Set IP Address
Fig. 3.8 Internet Protocol Page
Provide a valid IP address for your subsystem/controller’s Ethernet port. Consult your net-
work administrator for an IP address and the associated NetMask and Gateway values. You
may also key in “DHCP” if your local network supports automatic IP configuration.
i
NOTICE!
One drawback of using DHCP is that if cable disconnection or other unpredictable network
faults occur, your Ethernet port may be assigned with a different IP. This may cause problems
for the management sessions using the RAIDWatch manager. You may not be able to receive
important event messages. RAIDWatch and its sub-module, the Configuration Client (the
event notification utility), recognize a configured array through its Ethernet port IP.